Ever wondered how to measure your garage door springs accurately? Correct measurements are crucial for maintaining your garage door’s health and ensuring reliable commercial garage door springs repair. This article will guide you to effectively measure garage door springs vital for residential and commercial setups.

You’ll learn about wire size, spring length, and inside diameter, along with how to determine the spring wind. This knowledge is essential, especially when seeking professional commercial garage door spring repair assistance. Ready to become a measuring pro? Let’s get to it!

Table of Contents

Ways to Measure Garage Door Springs

Measuring your garage door springs correctly ensures your door operates smoothly and safely.

Here’s how you can accurately measure the springs, step by step.

Step 1: Measure Wire Size

The wire size of the spring is critical. To measure it, you’ll need to measure 10 coils and then 20 coils using a tape measure or a ruler.

Write down both measurements. Then, use an online wire size chart to determine the actual wire size by comparing your measurements.

Step 2: Measure Spring Length

Next, measure the length of the spring. Do this when the spring is relaxed (door in the down position).

Measure from one end to the other, excluding any end cones. This measurement helps in determining the strength and type of spring you need.

Step 3: Measure the Inside Diameter

The inside diameter of the spring is also essential. Look inside the spring coil; this measurement is already stamped there.

If not, measure across the inside of the spring. Standard sizes are often 1 3/4 inches, 2 inches, or 2 1/4 inches.

Step 4: Determine Spring Wind

Identify if the spring is a left-wind or right-wind.

Stand inside the garage looking outwards; a right-wound spring is on the left side, and a left-wound on the right.

This distinction is crucial for proper balance and operation.

Conclusion

Measuring your garage door springs accurately is essential for replacement or adjustment. These steps ensure the proper wire size, spring length, inside diameter, and spring wind direction measurements. If unsure about any step, consider consulting a professional to avoid risks.